Page Comparison

...

If you change this setting to True, the

If set to True, and you are using:

Resco Inspections: The Job Safety Analysis is available for service and job appointments.
Legacy Job Safety Tasks: The JSA process is used only for service appointments

that are

or edited in Service Management – and then synced – after the

.If you are using the Job Safety Analysis included with Inspections, this setting should be False. See Enabling Job Safety Analysis (with Resco Inspections) for more information

Setting	Description
UseJobSafetyTasks	Determines whether the JSA process is used. The default value is False. If False, the remaining settings in this section are not available.
Note
JobSafetyTaskListType	The JSA task list type. This value is required to use JSA and to make JSA tasks available to technicians.
JobSafetyStartStatus	The appointment status that is used to start the JSA process. When a technician selects this appointment status, the Job Safety tab opens automatically so the technician can complete JSA tasks. If a status is selected for both this setting and AutoStatusUpdate in the Mobile Device Global Settings section, we recommend that you do not use the same status for both.
JobSafetyUnsafeStatus	The appointment status that is used to indicate that work conditions are unsafe. You might want to create a status specifically for this purpose, such as UNSAFE. You can create this status in the Appointment Status Setup window in Service Management.
JobSafetyValidationLevel	The level of requirement for completing the Job Safety Task report before starting work on appointment tasks. The default value is REQUIRED. REQUIRED - The report must be completed to complete an appointment. OPTIONAL - The report does not have to be completed to complete an appointment.

Versions Compared