If you are using the Resco Inspections, you have the option to use the Job Safety Analysis (JSA) form. The questionnaire is tailored to ask specific questions about the site, to allow the Technician to identify hazards, and to document the steps they will take to remove risk. When the questionnaire is completed, a Job Safety Analysis report is generated as a PDF file and is attached to the service call.

If you would prefer to use the legacy Job Safety Analysis form and report, you do not have to do the setup steps below. However, on each device, you will need to go to Settings > MobileTech Settings and toggle Use Legacy Job Safety Analysis to Yes.

To enable the Job Safety Analysis form and report, you will need to complete the following steps:

Activate the Job Safety Analysis Form

In MobileTech Admin, go to Tools > Launch Resco Cloud Dashboard.
On the Questionnaire Designer tile, select Open Questionnaire Designer.
From the menu bar, select Import.
Navigate to the Program Files (x86)/Signature/MobileTech/Admin/Inspections/Job Safety Analysis folder.
Select Job Safety Analysis.
Select Open.
In the Questionnaires List window, scroll down to and select Job Safety Analysis.
From the menu bar, select Activate.

Import the Job Safety Analysis Report

Select the Resco Cloud tab.
From the Reports tile, select Open Reports.
Select Import.
The window opens to the previous location (Program Files (x86)/Signature/MobileTech/Admin/Inspections/Job Safety Analysis).
Select Job Safety Analysis.
Select Open.
In the Import New Mobile Report window, enter the Name of the report: Job Safety Analysis.

This report name must match the report filename.
Select OK.
Select the Job Safety Analysis report.
From the menu bar, select Activate.

Enabling Job Safety Analysis (with Resco Inspections)

Activate the Job Safety Analysis Form

Import the Job Safety Analysis Report