If you are using the Resco Inspections, you have the option to use the updated version of the Job Safety Analysis (JSA) form. With this version, the Safe Location question has been relocated towards the bottom of the form. This allows the technician the ability to complete the questions. Additionally, when indicating that a hazard exists, technicians can identify what task causes the hazard and how they can mitigate or eliminate the hazard. When the report is completed, the report is generated as a PDF.

If you would prefer to use the legacy Job Safety Analysis form and report, you do not have to do the setup steps below. However, on each device, you will need to go to Settings > MobileTech Settings and toggle Use Legacy Job Safety Analysis to Yes.

To enable the Job Safety Analysis form and report, you will need to complete the following steps:

Activate the Job Safety Analysis Form

In MobileTech Admin, go to Tools > Launch Resco Cloud Dashboard.
On the Questionnaire Designer tile, select Open Questionnaire Designer.
From the menu bar, select Import.
Navigate to the Program Files (x86)/Signature/MobileTech/Admin/Inspections/Job Safety Analysis folder.
Select Job Safety Analysis.
Select Open.
In the Questionnaires List window, scroll down to and select Job Safety Analysis.
From the menu bar, select Activate.

Import the Job Safety Analysis Report

Select the Resco Cloud tab.
From the Reports tile, select Open Reports.
Select Import.
The window opens to the previous location (Program Files (x86)/Signature/MobileTech/Admin/Inspections/Job Safety Analysis).
Select Job Safety Analysis.
Select Open.
In the Import New Mobile Report window, enter the Name of the report: Job Safety Analysis.

This report name must match the report filename.
Select OK.
Select the Job Safety Analysis report.
From the menu bar, select Activate.

Enabling Job Safety Analysis (with Resco Inspections)

Activate the Job Safety Analysis Form

Import the Job Safety Analysis Report